期刊文献+

喷淋脱硫塔喷嘴外流动数值模拟与实验研究 预览 被引量:5

Numerical Simulation and Experimental Study of Flows Outside the Nozzles of a Spray-type Desulfuration Tower
在线阅读 下载PDF
收藏 分享 导出
摘要 建立了一个喷淋脱硫塔喷嘴数值模型,研究了影响喷淋脱硫塔内气液传质的喷淋液流量与液膜平均破裂长度、喷嘴初始喷射角、液滴平均粒径的关系。设计了专门的测试平台和单匝螺旋喷嘴,采用快速CCD和数码照相机拍照对液膜和液滴运动进行了测试和分析。模型计算和实验结果均表明:液膜平均破裂长度随喷淋液流量加大而减小;液滴平均粒径减小随喷淋液流量加大而减小;在喷嘴出1:7缝隙高度等于4.25mm时,随流量的增大,喷嘴的喷射角随流量的增大反而变小,大于4.25mm后,在同一喷嘴缝隙高度下,喷射角随喷嘴流量的增加而增加。 Established was a numerical simulation model for nozzles of a spray-type desulfuration tower and studied was the relationship among the following items,which can influence the gas-liquid mass transfer inside a spray type desulfuration tower:spray liquid flow rate,average rupture length of the liquid film,initial jet flow angle of the nozzle and average liquid drop diameter.A special test platform and single-turn spiral nozzle were designed and the liquid film and liquiddrop movement were tested and analyzed by using a quick-speed CCD(Charge Coupled Device) with a digital camera being used to take pictures.Both the model calculations and experimental results show that the average liquid film rupture-length and the average liquid drop diameter will decrease with an increase of spray liquid flow rate.When the clearance height at the nozzle outlet is 4.25 mm,the spray angle of the nozzle will decrease with an increase of the liquid flow rate and when the clearance height at the nozzle outlet is greater than 4.25 mm,the spray angle under a same nozzle clearance height will increase with an increase of the liquid flow rate.
作者 周山明 金保升 孙志翱 ZHOU Shan-ming,JIN Bao-sheng,SUN Zhi-ao(Education Ministry Key Laboratory on Clean Coal Power Generation and Combustion Technology,Southeast University,Nanjing,China,Post Code:210096)
出处 《热能动力工程》 EI CAS CSCD 北大核心 2007年第6期 673-676,共4页 Journal of Engineering for Thermal Energy and Power
基金 国家重点基础研究发展规划基金资助项目(G19990221053).
关键词 液膜模型 破裂 喷射角 平均粒径 spray type desulfuration tower nozzle,liquid film model,rupture,spray angle,average particle diameter
作者简介 周山明(1969-),男,江西萍乡人,东南大学讲师,博士研究生.
  • 相关文献

参考文献11

  • 1SQUIRE H B. Investigation of the instability of a moving liquid film [J]. Brit J Appl Phys, 1953,4: 167- 169. 被引量:1
  • 2HAGERTY W W, SHEA J F. A study of the stability of plane liquid sheets[J]. J Appl Meeh, 1955,22:509- 514. 被引量:1
  • 3SHEN J, LI X. Atomization of an annular viscous liquid jet//Proc 7th Annu Conf Liquid Atom[ C]. Spray Sys: IL,ASS North and South America, 1994.50 - 54. 被引量:1
  • 4TAYLOR G. The dynamics of thin sheets of fluid disintegration of fluid sheets[C].Proc Roy Soc, 1959,253,313. 被引量:1
  • 5DOMBROWSKI N. The aerodynamic instability and disintegration of viscous liquid sheets [J].Chem Eng Sci, 1963,18,203. 被引量:1
  • 6SENECAL P K, SCHMIDT D P, NOUAR I, et al. Modeling high-speed vinous liquid sheet atomization [J]. International Journal of Multiphase Flow, 1999,25:1073 - 1097. 被引量:1
  • 7NONNENMACHER S, PIESCHE M. Desigh of hollow cone pressure swirl nozzles to atomize newtonian fluids [ J ]. Chemical Engineering Science, 2000,55:4339 - 4348. 被引量:1
  • 8刘乃玲,张旭.压力式螺旋型喷嘴雾化特性实验研究[J].热能动力工程,2006,21(5):505-507. 被引量:10
  • 9王乃华,高翔,骆仲泱,王庆东,岑可法.石灰浆液雾化喷嘴及其特性研究[J].热能动力工程,2001,16(3):247-249. 被引量:6
  • 10RAYLEIGH L. On the instability of jets[J].Proc London Math Soc, 1879, 10(4) :351 - 371. 被引量:1

二级参考文献9

共引文献14

同被引文献21

引证文献5

二级引证文献11

投稿分析

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部 意见反馈
新型冠状病毒肺炎防控与诊疗专栏